Guide

Warehouse Lighting Guide

How much light each part of a warehouse needs, how many LED high bays it takes, which fixture goes where, and what the switch from metal halide saves, with worked numbers.

Linear LED high bays lighting warehouse racking aisles

Step 1

How much light each area needs

Light level is measured in foot-candles, one lumen per square foot of floor. These are the IES recommended levels our lumens calculator uses:

AreaFoot-candlesUsual fixture
Bulk storage and open floor20 to 30UFO high bay
Racking aisles20 to 30Linear high bay
Packing, assembly and inspection30 to 50UFO or linear high bay
Office and break room30 to 50Troffer or flat panel
Loading dock, insideDepends on the work done thereVapor tight
Parking and yard1 to 5Shoebox area light

Packing and inspection areas are given the manufacturing level.

Step 2

How many LED high bays it takes

Multiply the floor area by the foot-candles to get the lumens the floor needs. Some light is lost to dirt, age and distance before it reaches the floor, and more of it the higher the fixture hangs, so divide by an allowance for the mounting height: 0.75 up to 20 ft, 0.68 up to 25 ft, 0.62 up to 30 ft and 0.55 above that. Then divide by the lumens of one fixture.

Worked example: 10,000 sq ft of bulk storage

At 25 foot-candles the floor needs 250,000 lumens. From a 25 ft mounting height, 250,000 divided by 0.68 is about 368,000 lumens of fixtures, or 18 UFO high bays at 150 W and 21,000 lumens each.

Those 18 fixtures draw 2.7 kW. The same count of 400 W metal halide high bays, at about 455 W each with the ballast, would draw about 8.2 kW. Over two shifts, about 4,160 hours a year, the difference is about 22,800 kWh, or about $3,400 a year at an example rate of 15 cents per kWh.

The high bay sizing table gives the count for 20 to 35 ft ceilings, and the lumens calculator does the sum for your own floor. Racking, aisle widths and spacing change the result, so we lay out every project before quoting it.

Step 3

Which fixture goes where

Open floor and bulk storage

UFO high bays from 100 to 300 W and up to 42,000 lumens, with the wattage and color temperature selectable. The 150 W and 240 W sizes also come in 277 to 480 V. Rated to -22°F.

Racking aisles

Linear high bays run their light along the aisle: the LHB09 from 130 to 300 W at up to 150 lumens per watt, and the LHB10 in 2, 3 and 4 ft lengths from 110 to 400 W at 160 lumens per watt. Both dim on 0-10V.

Loading docks and wash-down

Vapor tight fixtures sealed to IP65 and rated from -4°F to 113°F, in 4 and 8 ft lengths from 25 to 80 W, for water spray, dust and cold air from open dock doors.

Dock doors and walls

Full cutoff wall packs from 60 to 120 W with no uplight, sealed to IP65 and rated to -40°F, light the dock aprons and the building edge.

Yard and parking

Shoebox area lights from 100 to 500 W, IP65 and rated to -40°F, with slip fitter, arm and trunnion mounts and a photocell option for dusk to dawn.

Emergency lighting

Battery backup drivers keep fixtures lit through an outage, from 8 to 25 W models up to the 40 W UM series sized for high bays.

Step 4

Controls, cold and run hours

  • Motion sensors in the aisles. Racking aisles sit empty most of the day. Our PIR motion sensor works up to 40 ft and dims the light until someone walks in; the Bluetooth version is set from a phone.
  • Unheated buildings. LEDs come on at full brightness right away, with no warm-up. Check the rated minimum temperature: -22°F for the UFO and LHB09, -4°F for the LHB10 and the vapor tights, -40°F for the wall packs and area lights.
  • Run hours. The longer the lights run, the faster LED pays back. A building on two shifts runs its lights about 4,160 hours a year; one that never closes runs them 8,760 hours, so every watt saved counts about twice as much.

Before you buy

Warehouse lighting checklist

  • Measure the floor area of each zone and the mounting height.
  • Set the light level for each zone from the table above.
  • Count the fixtures with the lumens calculator, then check the spacing against the racking.
  • Check the listings on each exact model number: DLC, and UL or ETL. Each of our product pages and spec sheets names them.
  • Check the voltage and the cold rating against the building.
  • Work out the payback with your run hours and your rate in the ROI calculator.

Or send us the floor plan, ceiling heights and what you run now, and we lay it out and quote it. We supply warehouses nationwide from Honeoye Falls, New York, including LED lighting in Rochester, NY and LED lighting in Syracuse, NY.

Warehouse lighting questions

How many foot-candles does a warehouse need?
IES recommends 20 to 30 foot-candles for warehouse storage. Packing, assembly and inspection areas need more, closer to the 30 to 50 foot-candles used for manufacturing, and an office inside the warehouse needs 30 to 50 as well.
How many LED high bays do I need for a 10,000 square foot warehouse?
At 25 foot-candles from a 25 ft mounting height, about 18 UFO high bays at 150 W, or 11 at 240 W. Lower ceilings need fewer and higher ceilings more; the high bay sizing table covers 20 to 35 ft and the lumens calculator works out your own space.
Should I use UFO or linear high bays in a warehouse?
Use UFO high bays over open floor and bulk storage, where light needs to reach the floor from one point. Use linear high bays down racking aisles, where the light needs to run along the aisle. Many warehouses use both.
What lights work for loading docks?
Inside the dock, a sealed vapor tight fixture: ours are IP65 and rated from -4°F to 113°F, so they handle water spray, dust and cold air from open dock doors. Outside over the dock doors, a full cutoff wall pack rated to -40°F.
Do warehouse lights need motion sensors?
They are not required, but racking aisles are empty most of the day, and a sensor dims the light until someone walks in. Our high bay PIR sensors work up to 40 ft, and the Bluetooth version is set from a phone. In New York, NYSEG and RG&E's 2026 plan still lists lighting controls in its small business program.
Is 4000K or 5000K better for a warehouse?
Both are common. 5000K looks cooler and whiter, 4000K is a neutral white. Our UFO and linear high bays let you choose the color temperature, so you can set it to suit the space.